Detailed Description:
Methods/Design
- Participants after being textually and verbally informed about their rights, benefits and possible risks, objectives and methodologies of this study, all participants will sign a free and informed consent form.
- Study Design Prior to the rehabilitation protocol (RP), participants will perform one adaptation session to all the functional tests that will be applied to minimize learning bias. In the second session after 5 minutes warm up in a cycle ergometer (CEE), the Time Up and Go (TUG) test will be applied, followed by the isometric strength test. In the third day, after the same warm up, one repetition maximum testing will be conducted. At the end of the RP, all the tests will be repeated. Blood samples will be collected at baseline (day 0), 1 month (day 30 after RP) and at 2 months (day 60 after RP).
2.1. Rehabilitation protocol (RP) The RP will consist of 3 exercise session/week for 8 weeks. Each session will begin with the evaluation of pain by the participants. If the pain is higher than four, an analgesic protocol (AP) containing ultra-sound, laser or transcutaneous electrical nerve stimulation (TENS) will be applied. After the AP, the participant will just execute the rehabilitation protocol if the pain decreased to or lower than four. Starting with a warm up exercise in a cycle ergometer (CEE), for 5 minutes at free cadence, then the intensity will be set at 90% of the intensity obtained during the incremental test (see item 2.2a) and maintained for 10 min. Afterward, four sets (8-12 repetitions) of three different resistance exercises (RE) (leg press, knee extension and knee flexion) will be performed at 70% of the load correspondent to 1RM test (see item 2.2b) with one minute interval between sets and exercises. During CEE Borg scale will be taken every two minutes and during RE the omnibus (OMNI) scale taken at the end of every set to monitor the intensity. At the end of the session, cool down global stretching exercises for inferior members will be performed and the VAS evaluated again. Ten seconds of tension for each stretching position targeting the hamstrings, quadriceps, gluteus maxim ums, gastrocnemius, thigh adductors and abductors.
2.2. Rehabilitation intensity parameters.
- Cycle ergometer incremental test (CEEIT). After 5 minutes warm up at free cadence in a cycle ergometer, the intensity will be increased every 3 minutes until the participants register 11 to 13 in Borg scale which is consider a moderate intensity and to be correlated to blood lactate concentration threshold and anaerobic threshold, respectively .
- One repetition maximum. The test starts with a warm up of 5 to 10 repetitions with estimated moderate load (± 40-60% of 1RM). After 1 minute rest 3 to 5 repetitions are performed with higher load (±60-80% of 1RM) with 5 minutes rest. Then one attempt at estimated 1RM is given. If the participants fail to lift the load for two repetitions the test stops, otherwise after 5 minutes rest the load is increased and the test is performed again. Only five attempts per day are permitted to maintain the test reliable.
Sample size calculation The estimation of sample size was determined on the basis of a greater improvement of subscale physical function of the WOMAC score, using G.Power 3.15 software. Based on 10% expected difference between baseline measure and after RP and a standard deviation of 30 on physical function of WOMAC, 65 participants are needed with significance level of 0.05, and power of 80%.