Cairo university
Cairo, Egypt
NCT Number: NCT05606874
Retention rate and caries preventive effect of preheated flowable resin composite used as a pit and fissure sealant versus conventional resin-based fissure sealant in patients with permanent molars with deep pit and fissure over one year follow up. A randomized clinical trial
Looking for future studies?
Notify Me16 year–22 year
All sexes
Interventional
Not applicable
Cairo, Egypt
Statement of the problem:
Pit and fissure sealant placement is considered as an effective modality for prevention of caries on occlusal surfaces. Penetration, retention and lateral wall adaptation are the key factors in success of pit and fissure sealant restorations .
The retention is very critical for the sealing material and the successful penetration of the material into the pits and fissures However, the morphology of the fissures significantly influences the penetration of the sealing material occlusal fissure pattern like in deep and narrow fissures like I-type and IK- type where lesser penetration may be encountered fillers are added to the pit and fissure sealants in order to increase their wear and abrasion resistance. However, these fillers could lead to increase in the viscosity with subsequent decrease in the penetration.
Rationale:
According to a systematic review, they found that preheating of resin composite apparently increases the flowability of regular consistency composites, which improves the adaptation of the material into the cavity walls. Also studied the effect of heat and sonic vibration on penetration of flowable resin composite, they found that higher penetration was associated with heat compared with the conventional application method. So, this proposal is introduced with the hypothesis that preheating of filled fissure sealants may enhance their flowability and penetration especially into those fissures with complex structure.
Healthy volunteers accepted: Yes
Only the study team can determine whether someone qualifies for participation.
Inclusion criteria
participant:
Teeth
-
Exclusion criteria
participant:
Teeth:
The occlusal fissures will be etched with a 37% phosphoric acid gel for 30 s. After rinsing the enamel with water for 30 s the enamel will be dried for 15 s with compressed air. After completing the fissure preparations a single coat of adhesive (3M ESPE ADPER ,USA) will be applied to the etched surface ,dried under gentle air flow for 2- 3 s and light cured for 20 s using a LED light curing unit with a 1000 mw output .Conventional resin fissure sealant (total etch), (UltraSeal XT®, Ultradent, USA) will be applied to the etched pits and fissures. After removing the rubber dam the occlusion will be checked the sealant will be adjusted with a composite finishing bur and polished with polishing points.
Other names: (Filtek™ Z350Xt Flowable Restorative, 3M ESPSE, USA)
The occlusal fissures will be etched with a 37% phosphoric acid gel for 30 s. After rinsing the enamel with water for 30 s the enamel will be dried for 15 s with compressed air. After completing the fissure preparations a single coat of adhesive (3M ESPE ADPER ,USA) will be applied to the etched surface ,dried under gentle air flow for 2- 3 s and light cured for 20 s using a LED light curing unit with a 1000 mw output .Conventional resin fissure sealant (total etch), (UltraSeal XT®, Ultradent, USA) will be applied to the etched pits and fissures. After removing the rubber dam the occlusion will be checked the sealant will be adjusted with a composite finishing bur and polished with polishing points.
Other names: (total etch), (UltraSeal XT®, Ultradent, USA)
Time frame: T1: 3 months
Retention criteria
Time frame: T2: 6 months
Retention criteria
Time frame: T3: 12 months
Retention criteria
Time frame: T1: 3 months
ICDAS-II visual criteria
Time frame: T2: 6 months
ICDAS-II visual criteria
Time frame: T3: 12 months
ICDAS-II visual criteria
Cairo University
Other
Retention Rate and Caries Preventive Effect of Preheated Flowable Resin Composite Used as a Pit and Fissure Sealant Versus Conventional Resin-based Fissure Sealant in Patients With Permanent Molars With Deep Pit and Fissure Over One Year Follow up. A Randomized Clinical Trial
OpenTrials presents study information sourced from ClinicalTrials.gov. The official registry record should be consulted for the latest information.
View the official ClinicalTrials.gov record (opens in a new tab)This listing is for discovery and informational purposes only. It is not medical advice, does not guarantee that a study is recruiting, and does not determine eligibility. Contact the study team and a qualified healthcare professional when considering participation.
Published trials that share one or more normalized conditions with this study.
NCT04127357
Dental Caries in Children, Pit and Fissure Sealant
View Trial DetailsNCT06729788
Permanent Molars, Pit and Fissure Sealant
Tanta, ELGharbia, Egypt
View Trial DetailsNCT06493942
Pit and Fissure Sealant, Van der Woude syndrome
View Trial DetailsNCT07705633
Fissure Sealants, Pit and Fissure Sealants
Suez, Egypt
View Trial Details