Nahda University
Banī Suwayf, Beni Suweif Governorate, 62511, Egypt
NCT Number: NCT07669324
Aim of The Study This study aims is to evaluate color change, dentin hypersensitivity and patient satisfaction after different bleaching techniques at different time intervals.
Materials(subjects)& Methods
* Chemically activated bleaching kit. * Light activated bleaching kit. This will be a randomized single-blind clinical trial, patients attending the faculty. Thirty-two patients will be selected for the study. Oral hygiene steps will be taken at the first visit, as well as scaling and polishing of the teeth. Patients will be divided into two groups according to the bleaching technique used. Group 1: chemical bleaching, Group 2: light activated bleaching.
Color change measurements:
Tooth color measurements will be performed at baseline T0, immediately after bleaching treatment T1, 1-week T2 and 1-month T3 after bleaching using a spectrophotometer. The whiteness index will be also calculated to verify the perceived bleaching effect.
Dentin hypersensitivity will be evaluated at baseline D0, immediately after bleaching treatment D1, 1 week (D2) and 3 month (D3) after bleaching using Visual Analogue Scale VAS numbered from 0 (no pain) to 10 (maximum extreme pain).
At the end of the study (3 months) a questionnaire was given to the patients to assess their satisfaction with bleaching treatment.
Looking for future studies?
Notify Me18 year–45 year
All sexes
Interventional
Not applicable
Banī Suwayf, Beni Suweif Governorate, 62511, Egypt
patients attending the faculty clinic will be screened and selected for the study according to the following inclusion criteria and exclusion criteria, inclusion criteria;
Exclusion criteria
Bleaching techniques:
Color change measurements:
Tooth color measurements will be performed at baseline T0, immediately after bleaching treatment T1, 1-week T2 and 1-month T3 after bleaching using a spectrophotometer. The measured values will be recorded in the units of CIELab color space. CIE L* parameter shows the degree of lightness, a* is indicative of redness/greenness, and b* indicates yellowness/blueness. Variations in L*, a*, and b* axes and chromatic alteration will be performed at each period and compared to baseline using the following calculation: ΔE* = [(ΔL*)2 + (Δa*)2 + (Δb*)2]1/2.
Whiteness index (WID):
The whiteness index will be also calculated to verify the perceived bleaching effect. The WID is a simple linear formulation that uses the CIELab chromatic coordinate values, in which the higher the values obtained, the greater the bleaching effect provided by a given procedure. WID will be calculated using the following formula: WID = (0.511 × L ∗) - (2.324 × a ∗) - (1.100 × b ∗).
Evaluation of postoperative dentin hypersensitivity:
Dentin hypersensitivity will be evaluated at baseline D0, immediately after bleaching treatment D1, 1 week (D2) and 3 month (D3) after bleaching using Visual Analogue Scale VAS numbered from 0 (no pain) to 10 (maximum extreme pain).
Evaluation of patient satisfaction:
At the end of the study (3 months) a questionnaire was given to the patients to assess their satisfaction with bleaching treatment. Multi-item measure of satisfaction will be used to evaluate patients' perceptions of importance and performance of four characteristics of a bleaching treatment; final tooth color, color stability, length of treatment and comfort during treatment. Patients will be asked to rate the perceived importance of each characteristic on a 7-point Likert scale anchored by 1='Not at all important' and 7='Very important'. The perceived performance of each characteristic will be assessed on a scale anchored by 1='Very bad' and 7='Excellent'. Difference between performance and importance scores of individual service characteristics will be then calculated to form a third variable, the gap score, which will be used as an indicator of patient satisfaction. Also, the overall satisfaction of patients with the bleaching service will be measured separately on a 7-point scale anchored by 1='Not at all satisfied' and 7='Very satisfied'.
Healthy volunteers accepted: Yes
Only the study team can determine whether someone qualifies for participation.
Inclusion criteria
Exclusion criteria
bleaching procedure was conducted according to the manufacturer's instructions. Retractor was set in place, the teeth were dried by air stream, the lips were lubricated with Vaseline, a cheek retractor was placed, and isolation was achieved using cotton rolls and the gingival soft tissues were isolated by protective Liquidam (Philips, Andover, MA), Labial surfaces of the teeth 11, 12, 21, 22 were then covered with whitening gel in about 1-2mm thick layer. one 20 min session was done.protective eye wear for both patient and operator was used,d, the bleaching gel was applied, and agitated, and then light activation was used for the period of the session.
The bleaching procedure was conducted according to the manufacturer's instructions. Retractor was set in place, the teeth were dried by air stream, the lips were lubricated with Vaseline, a cheek retractor was placed, and isolation was achieved using cotton rolls and the gingival soft tissues were isolated by protective Liquidam (Philips, Andover, MA), Labial surfaces of the teeth 11, 12, 21, 22 were then covered with whitening gel in about 1-2mm thick layer. one 20 min session was done.the bleaching gel was applied and agitated and then left on tooth surface for the period of the session
Time frame: three months
Tooth color measurements will be performed at baseline T0, immediately after bleaching treatment T1, 1-week T2 and 1-month T3 after bleaching using a spectrophotometer. The measured values will be recorded in the units of CIELab color space. CIE L* parameter shows the degree of lightness, a* is indicative of redness/greenness, and b* indicates yellowness/blueness. Variations in L*, a*, and b* axes and chromatic alteration will be performed at each period and compared to baseline using the following calculation: ΔE* = [(ΔL*)2 + (Δa*)2 + (Δb*)2]1/2.
Time frame: three months
Dentin hypersensitivity will be evaluated at baseline D0, immediately after bleaching treatment D1, 1 week (D2) and 3 month (D3) after bleaching using Visual Analogue Scale VAS numbered from 0 (no pain) to 10 (maximum extreme pain).
Time frame: 1 month
whiteness index was also calculated to verify the perceived bleaching effect. The WIDis a simple linear formulation that uses the CIELab chromatic coordinate values, in which the higher the values obtained, the greater the bleaching effect provided by a given procedure. WID will be calculated using the following formula WID = (0.511 × L*) - (2.324 × a*) - (1.100 × b*)
Nahda University
Other
Comparative Evaluation of the Effect of Chemical and Light Activated Bleaching Techniques on Color Change, Dentin Hypersensitivity and Patient Satisfaction. (In-vivo Study)
OpenTrials presents study information sourced from ClinicalTrials.gov. The official registry record should be consulted for the latest information.
View the official ClinicalTrials.gov record (opens in a new tab)This listing is for discovery and informational purposes only. It is not medical advice, does not guarantee that a study is recruiting, and does not determine eligibility. Contact the study team and a qualified healthcare professional when considering participation.
Published trials that share one or more normalized conditions with this study.
NCT07669818
Dentin Hypersensitivity, Dentin Sensitivity
Cairo, Other, Egypt
View Trial DetailsNCT07593508
Dental Pulp Diseases, Dental Pulp Exposure
Huế, Vietnam
View Trial DetailsNCT07511530
Dentin Hypersensitivity, Dentin Sensitivity
Amman, Jordan
View Trial DetailsNCT07297732
Dentin Hypersensitivity, Dentin Sensitivity
Las Vegas, Nevada, United States
View Trial Details