3D Scanning as an Advanced Tool for Identifying Tooth Lesions in Children

Experimental design: This study is based on information obtained in a pilot study in the framework of a "validation study" previously to an in vivo study. Investigators will be trained in 3 different indices to register and grade the lesions to obtain reproducible data. International caries detection and assessment system (ICDAS - Pitts et al., 2013), Basic Erosive Wear Examination (BEWE - Schlueter et al., 2020), and TF index (Thylstrup & Fejerskov, 1978) will be used for detection of caries lesions, erosive tooth wear, and dental fluorosis, respectively.

Patient recruitment: The research protocol was approved by the Institutional Review Board (# 24373). After IRB approval and previous to any intervention, a signed informed consent form will be obtained from the legal guardians of each child. Children aged between 3 and 12 years old, presenting any fully erupted primary teeth, searching for dental treatment at the Department of Pediatric Dentistry, Indiana University School of Dentistry will be included in this study.

Visual examination: Before visual examination, teeth will be cleaned using a bristle brush, prophylaxis paste and mirror, washed, and carefully air dried. Isolator will be used to control the saliva during the prophy. For the index detection using the visual examination of the different indices on each tooth's, the primary upper and lower incisors, canines and molars will be dried with compressed air, and each tooth's buccal, palatal/lingual, and occlusal surfaces will be examined visually using adequate dental instruments for each index. A headlight or overhead/dental unit light will be directly over the teeth. The diagnosis of caries lesions, erosive tooth wear, and dental fluorosis will be carried out separately. ICDAS, BEWE, and TF systems will be registered and graded the lesions according to table 1. Once the visual examination is completed, the data will be stored to be compared with intraoral scanner later.

Digital scanning: After completing the visual examination, the investigators will be calibrated using 3Shape TRIOS 4 intraoral scanner and 3Shape Unite software for data processing according to the manufacturer's instructions. The primary teeth's buccal, palatal/lingual, and occlusal surfaces will be scanned with a 3D intraoral scanner (IOS) (TRIOS 4; 3Shape A/S, Copenhagen, Denmark) and register with a number. There will be no headlight or overhead/dental unit light directly over the teeth to be scanned. Subsequently, using the 3Shape Unite software, each tooth will be analyzed separately on all its surfaces (as with the visual examination, the ICDAS, BEWE, and TF, indices will be detected) by using the 3Shape software and an entire screen of a 15.5" Dell laptop. Following, the 3D image will be magnified until only lesion can be seen and each surface will be observed systematically for each index.

Inclusion criteria

Children aged between 3 and 12 years old, presenting at least one fully erupted primary tooth.

Exclusion criteria

• Unerupted primary teeth.
• Restored teeth.
• Children under 3 or older than 12 years old.
• Children using medication.