Skip to main content
OpenTrials
Completed

NCT Number: NCT05655169

Which is Better Piezosurgery or Piezosurgery With Laser in Accelerating Orthodontic Tooth Movement

Sixty patients who need extraction-based treatment of the maxillary first premolars with subsequent retraction of the maxillary anterior teeth will be divided randomly into three groups: piezocision group, piezocision with low-level laser therapy group, and control group. In each group, after the levelling and alignment phase is completed, the rectangular stainless steel archwires (0.019" × 0.025") will be inserted, then after two weeks, the en masse retraction will be started via closed nickel-titanium coil springs applying 250 g of force per side. For anchorage, mini implants will be inserted between the second premolars and the first molar on each side.

Completed

Looking for future studies?

Notify Me

Key information

Age range

17 year–28 year

Sex eligibility

All sexes

Study type

Interventional

Phase

Not applicable

Primary location

University of Damascus

Damascus, Syria

About this study

Regarding the Piezocision, vertical soft-tissue incisions will be made on the buccal and palatal gingiva. One incision will be made between the roots of the six upper anterior teeth, and two incisions will be made between the upper canines and the second premolars. The incisions will be 5 mm long and start 4 mm apical to the interdental papilla. Then a piezosurgery knife will be inserted to perform the cortical alveolar incisions with 3-mm in-depth and 8 mm in length. No suturing will be needed.

Regarding the piezocision with the later application of low-level laser therapy (LLLT):

After six weeks of piezosurgery, a diode laser (wavelength: 810 nm and exposure time of 10 seconds\\point) 10 seconds per point will be applied on each tooth of the six maxillary anterior teeth according to this protocol: the root will be divided theoretically into two halves; gingival and cervical, and the laser will be applied in the center of each half from both buccal and palatal sides which means four application points and total energy of 16 Joules per tooth. LLLT irradiation will be performed in the sixth week after the onset of mass retraction (day 0). After that, irradiation is repeated on days 3, 7, and 14, then every two weeks, until the class I canine relationship is achieved and/or spaces lateral to incisors are closed

Who can participate

Healthy volunteers accepted: No

Only the study team can determine whether someone qualifies for participation.

Inclusion criteria

  • Adult healthy patients, Male and female, Age range: 17-28 years.
  • Class II Division 1 malocclusion :
  • Mild/moderate skeletal Class II (sagittal discrepancy angle ≤7)
  • Overjet ≤10
  • Normal or excessive facial height (Clinically and then cephalometrically assessed using these three angles: mandibular/cranial base angle, maxillary/mandibular plane angle, and facial axis angle)
  • Mild to moderate crowding ≤ 4
  • Permanent occlusion.
  • Existence of all the upper teeth (except third molars).
  • Good oral and periodontal health:
  • Probing depth < 4 mm
  • No radiographic evidence of bone loss.
  • Gingival index ≤ 1
  • Plaque index ≤ 1

Exclusion criteria

  • Medical problems that affect tooth movement (corticosteroid, nonsteroidal anti-inflammatory drugs (NSAIDs), …)
  • Presence of primary teeth in the maxillary arch
  • Missing permanent maxillary teeth (except third molars).
  • Poor oral hygiene or Current periodontal disease:
  • Probing depth ≥ 4 mm
  • radiographic evidence of bone loss
  • Gingival index > 1
  • Plaque index > 1
  • The patient had previous orthodontic treatment

Treatment and study plan

Piezosurgery and GaALAs diode laser

Procedure

One incision will be made between the roots of the six upper anterior teeth, and two incisions will be made between the upper canines and the second premolars. The incisions will be 5 mm long and start 4 mm apical to the interdental papilla.

After six weeks of piezosurgery, GaALAs diode laser (wavelength: 810 nm and exposure time of 10 seconds\\point) 10 seconds per point will be applied.

Piezosurgery

Procedure

One incision will be made between the roots of the six upper anterior teeth, and two incisions will be made between the upper canines and the second premolars. The incisions will be 5 mm long and start 4 mm apical to the interdental papilla.

Fixed orthodontic appliance

Other

After the levelling and alignment phase is completed, the rectangular stainless steel archwires (0.019" × 0.025") will be inserted, then after two weeks, the en masse retraction will be started via closed nickel-titanium coil springs applying 250 g of force per side.

Primary outcomes

  1. The rate of en-masse retraction of upper anterior teeth

    Time frame: This will be assessed at the end of the active treatment, which is expected to occur within five months

    The rate of en-masse retraction of upper anterior teeth (mm/month) in each group will be calculated. This outcome will be measured by the following steps: Drawing a projection from the upper canine apex to the middle palatal bone line. Drawing a projection from the upper central incisor edge to the middle palatal bone line. Drawing a projection from the mesial ending of the third palatal rugae to the middle palatal bone line. Measuring the distance (mm) between the canine apex and third palatal rugae projections. Measuring the distance (mm) between the central incisor edge and third palatal rugae projections. The rate of en-masse retraction will be measured by dividing the distance between the canine apex/central incisor edge projections and the third palatal rugae projection by the time elapsed between assessment times.

  2. Change in the anteroposterior movement of the molar

    Time frame: Time 0:1 day before the beginning of the retraction phase (baseline). Time 1: after 1 month from the beginning. Time 2: after 2 months. Time 3: after 3 months. Time 4: after 4 months. Time 5: immediately after the end of the retraction phase

    The anteroposterior movement of the molar (mm/month) in each group will be calculated. This outcome will be measured on the dental casts by drawing two projections from the central groove of the first maxillary molar and the mesial ending of the third palatal rugae to the middle palatal bone line. The anteroposterior movement of the first maxillary molar (mm) will be measured by dividing the distance between the two projections by the time elapsed between assessment times.

  3. Change in the inter-canine width

    Time frame: Time 0:1 day before the beginning of the retraction phase (baseline). Time 1: after 1 month from the beginning. Time 2: after 2 months. Time 3: after 3 months. Time 4: after 4 months. Time 5: immediately after the end of the retraction phase

    The change in the inter-canine width (mm/month) in each group will be calculated. Assessment will be performed by measuring the distance between the cusp tips of the two upper canines. This variable will be measured on dental casts.

  4. Change in the inter-molar width at 5 months

    Time frame: Time 0:1 day before the beginning of the retraction phase (baseline). Time 1: after 1 month from the beginning. Time 2: after 2 months. Time 3: after 3 months. Time 4: after 4 months. Time 5: immediately after the end of the retraction phase

    The change in the inter-molar width (mm/month) in each group will be calculated. Assessment will be performed by measuring the distance between the central groove of the two first maxillary molars. This variable will be measured on dental casts.

Secondary outcomes

  1. Change in molar antero-posterior position

    Time frame: Time 0:1 day before the beginning of the retraction phase (baseline). Time 1: after 1 month from the beginning. Time 2: after 2 months. Time 3: after 3 months. Time 4: after 4 months. Time 5: immediately after the end of the retraction phase

    The amount of distance being travelled by the first molars is going to be measured on study models taken at monthly intervals until the end of the retraction phase.

Sponsors and collaborators

Lead sponsor

Damascus University

Other

Registry information

Official study title

Effectiveness of Piezocision or the Combination of Piezocision and Low-level Laser Therapy on Orthodontic Tooth Movement During En-masse Retraction and the Associated Dentoalveolar Changes: A Three-arm Randomized Controlled Trial

Important dates

Study start
2019
Primary completion
2021
Study completion
2021
First posted
Dec 19, 2022
Registry last updated
Nov 12, 2024

OpenTrials presents study information sourced from ClinicalTrials.gov. The official registry record should be consulted for the latest information.

View the official ClinicalTrials.gov record (opens in a new tab)

This listing is for discovery and informational purposes only. It is not medical advice, does not guarantee that a study is recruiting, and does not determine eligibility. Contact the study team and a qualified healthcare professional when considering participation.

Published trials that share one or more normalized conditions with this study.