Skip to main content
OpenTrials
Recruiting

NCT Number: NCT07237386

Comparing the Ceriter Stride One, a Pressure-sensitive Smart Insole, With Gait Parameters Measured on the GRAIL in Neurological Populations

Ceriter Stride-One soles have been available on the market for several years. One of the features of these soles is that they can measure gait parameters while patients walk around in a functional environment. This can provide a more realistic picture of gait patterns compared to measurements taken in a laboratory setting.

At UZ Ghent, we use an advanced gait lab to measure gait parameters before and after a training period on this system, the GRAIL system. We measure similar parameters to the Ceriter Stride-One soles (support phase, swing phase, pressure on the left leg and on the right leg). In this study, we would apply these insoles to patients who are tested on the GRAIL system, according to standard care, during the test in order to compare the parameters measured by the insoles and the parameters measured by the GRAIL system. This information will give us more insight into the accuracy of the data measured with these soles so that we can apply them in future studies conducted not in the gait lab but in functional environments.

Patients who are eligible for GRAIL therapy and are therefore routinely tested are patients who are admitted or undergoing outpatient rehabilitation at the rehabilitation centre of UZ Ghent after a brain injury, stroke, spinal cord injury or amputation. Given the subject of the research and the difficulty of fitting a sole into the shoe of a prosthetic leg, only people with brain and spinal cord injuries are asked to participate in the study.

Participants must be able to step onto the GRAIL treadmill with the help of one therapist and must be able to walk for at least six minutes. Participants have to weigh less than 120 kg (treadmill safety system restriction).

As standard in our setting, participants train for 5 weeks, twice a week for 30 minutes on the GRAIL treadmill. Before and after their training period, they walk on the GRAIL for about 2 minutes and we measure a number of gait parameters: speed, step width, step length, duration of the support phase and swing phase, and how much they support on their left and right legs.

Some of these parameters can also be measured by the Ceriter Stride One sole. The aim is to investigate how comparable these data are. If these data are sufficiently comparable, the soles can be used to measure the ratio of the support and swing phases during walking in everyday tasks or in environments other than a laboratory setting.

Recruiting

Interested in participating?

Request Info

Key information

Conditions

Stroke Acquired Brain Injury Brain Diseases Brain Injuries Brain Injuries, Traumatic Cardiovascular Diseases Central Nervous System Diseases Cerebrovascular Disorders Craniocerebral Trauma Incomplete Spinal Cord Injury Nervous System Diseases Spinal Cord Diseases Spinal Cord Injuries Trauma, Nervous System Traumatic Brain Injury Vascular Diseases Wounds and Injuries

Sex eligibility

All sexes

Study type

Interventional

Phase

Not applicable

Primary location

Who can participate

Healthy volunteers accepted: No

Only the study team can determine whether someone qualifies for participation.

Inclusion criteria

  • Persons suffering a lesion of the central nervous system (stroke, incomplete spinal cord injury, acquired brain injury) who are admitted to the rehabilitation center of the Ghent University hospital or who follow therapy at the rehabilitation center of the Ghent University hospital as outpatients.
  • Patients need to be able to walk independently during at least 6 minutes without the need of an extra person (Functional ambulation category 3 or higher).

Exclusion criteria

  • Severe orthopedic trauma or acute trauma of the lower limbs influencing walking
  • body weight that exceeds 120 kg.
  • severe dizziness that makes exercising in standing position impossible
  • severe cardio-pulmonary disorders that require monitoring during exercising
  • patients who do not understand the task that needs to be performed in this study.

Treatment and study plan

Wearing smart insoles

Device

Participants will wear Ceriter Stride One insoles during walking on an instrumented treadmill. Parameters (like stance phase duration and swing phase duration) measured by the insoles will be compared to the same parameters measured by the instrumented treadmill with accompanying 3D motion capture system.

Primary outcomes

  1. Swing phase as a percentage of the duration of one stride

    Time frame: Single point of assessment at inclusion

    For each leg the duration of the swing phase will be determined as a percentage of the duration of one stride. Using the GRAIL system this will be calculated as de duration between toe-off and the following heel contact of the same leg. Using the ceriter stride one insole this will be calculated by determining the toe-off and following heel contact based on a cut-off value using the pressure sensors in the insole. For both devices it will be expressed as a percentage of the duration of one stride.

  2. Stance phase as a percentage of the duration of one stride

    Time frame: Single point of assessment at inclusion

    For each leg the duration of the stance phase will be determined as a percentage of the duration of one stride. Using the GRAIL system this will be calculated as de duration between heel contact and the following toe-off of the same leg. Using the ceriter stride one insole this will be calculated by determining the heel contact and following toe-off based on a cut-off value using the pressure sensors in the insole. For both devices it will be expressed as a percentage of the duration of one stride.

Secondary outcomes

  1. Stance phase as a percentage of the duration of one stride after 5 weeks

    Time frame: Single point of assessment at 5 weeks after inclusion

    For each leg the duration of the stance phase will be determined as a percentage of the duration of one stride. Using the GRAIL system this will be calculated as de duration between heel contact and the following toe-off of the same leg. Using the ceriter stride one insole this will be calculated by determining the heel contact and following toe-off based on a cut-off value using the pressure sensors in the insole. For both devices it will be expressed as a percentage of the duration of one stride.

  2. Swing phase as a percentage of the duration of one stride after 5 weeks

    Time frame: Single point of assessment at 5 weeks after inclusion

    For each leg the duration of the swing phase will be determined as a percentage of the duration of one stride. Using the GRAIL system this will be calculated as de duration between toe-off and the following heel contact of the same leg. Using the ceriter stride one insole this will be calculated by determining the toe-off and following heel contact based on a cut-off value using the pressure sensors in the insole. For both devices it will be expressed as a percentage of the duration of one stride.

  3. Ratio of stance phase duration

    Time frame: Single point of assessment at inclusion

    The ratio of the stance phase duration of the paretic leg will be calculated compared to the non-paretic leg. Or if both legs are involved, the ratio of the most impaired leg on the least impaired leg. This will determine the asymmetry in stance phase duration during walking.

  4. Ratio of stance phase duration after 5 weeks

    Time frame: Single point of assessment at 5 weeks after inclusion

    The ratio of the stance phase duration of the paretic leg will be calculated compared to the non-paretic leg. Or if both legs are involved, the ratio of the most impaired leg on the least impaired leg. This will determine the asymmetry in stance phase duration during walking.

Study contacts

Contact information is provided by the study sponsor or research team.

Anke Van Bladel, Professor

CONTACT

[email protected]

+32468181632

Sponsors and collaborators

Lead sponsor

University Hospital, Ghent

Other

Collaborators

  • University Ghent

Registry information

Important dates

Study start
2025
Primary completion
2026
Study completion
2026
First posted
Nov 19, 2025
Registry last updated
Nov 19, 2025

OpenTrials presents study information sourced from ClinicalTrials.gov. The official registry record should be consulted for the latest information.

View the official ClinicalTrials.gov record (opens in a new tab)

This listing is for discovery and informational purposes only. It is not medical advice, does not guarantee that a study is recruiting, and does not determine eligibility. Contact the study team and a qualified healthcare professional when considering participation.

Related clinical trials

Published trials that share one or more normalized conditions with this study.